PF Sense Transparent Bridge

[Pal]

Hi,

I have reviewed and following the instructions in the following post which shows Running on a Transparent pfSense Bridge. However, I am not able to get this to work with my setup.

In my current setup I have a WAN connection from the customer coming into port 1 (DHCP) on the PF sense with default vlan 4091. Port 2 on the pf sense which is the Lan port, I have assigned an static ip address of 192.168.0.5 and vlan 999. I have then bridged the WAN and LAN (PORT 1 AND 2). I have added rules to the bridge to reject any traffic but allow only access to ip 192.168.0.15. I was not able to see the end advice as outlined in the image provided. Do I need to modify my settings?

[Jkamffer]

Did you follow the instructions posted here ?

Running on a Transparent pfSense Bridge

This article will show you how to setup pfSense as a transparent bridge, and installing adam:ONE (DNSthingy) to filter all traffic. [pfSense%20Bridge%20w%20%20DNSthingy] Configure pfSense in Bridge Mode Disable NAT [disable_nat] Enable Packet Filter for Bridge Interface Find the setting called net.link.bridge.pfil_bridge and set the value to 1 Also change net.link.bridge.pfil_member to a value of 0 [enable_filter] Create the Bridge Go to Interfaces / Assignments / Bridges and click t…

Would just suggest doing a complete factory reset when attempting this and also don’t restore from a backup. Once the above is complete, then install adam.